Leveling a Stacked Laundry Center
How to Level your Maytag Stacked Laundry Center
IMPORTANT: Level washer/dryer properly to reduce excess noise and vibration.
With washer/dryer in its final location, place a level on top edges of washer/dryer. Use side seam as a guide to check levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer back and forth to make sure all four feet make solid contact with floor. If washer/dryer is level, skip to step 3 (27" models) or step 4 (24" models).
If washer/dryer is not level, prop up front of washer/dryer about 4" (102 mm) with a wood block or similar object that will support weight of washer/dryer. On 27" models, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts clockwise on feet until they are about 1/2" (13 mm) from the washer/dryer cabinet. Then turn the leveling foot clockwise to lower the washer/dryer or counterclockwise to raise the washer/dryer. On 24" models, adjust the feet up or down as necessary. On all models, remove wood block and lower washer/dryer. Recheck levelness of washer/dryer and repeat as needed.
When washer/dryer is level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer/dryer cabinet.
HELPFUL TIP: You may want to prop washer/dryer with a wooden block.
For further questions or more information on installing your Stacked Laundry Center, see your Installation Instructions.
If you would like to download or view product literature for your appliance, please visit our Manuals and Literature page.